Press Inspector
Ann Swann Personnel
Midrand, South Africa
3d ago
source : Job Placements

Duties and Responsibilities :

  • Review the lot tickets and check die drawings for the purpose of identifying the critical quality characteristics.
  • Understand the critical quality characteristics for each and every customer / die
  • Decide on what instruments are needed including gauges.
  • Ensure that run roller, lift-off arms, Thermatex on the cooling table etc. Is in good condition.
  • Inspect the extrusion front ends for shape and surface during breakthrough and cut samples on all dies.
  • Cut the sample piece on the second billet and thereafter on every 5th billet. Check surface quality and dimensions as specified on the drawing.
  • Check flatness before and after quench to determine if its a die problem or quench problem
  • Check all dimensions, pay special attention to important dimensions, use data book, and take note of special tolerances on die drawings
  • Verify exit temperature by rubbing sections with tempil sticks.
  • Verify that front-end scrap, back-end scrap and discard cut are correct
  • Verify if the correct process parameters (speed, temperature, puller tension etc.) specified on lot tickets, procedures etc. are adhered to.
  • In case of stopped dies or speed reduced dies, fill the dies stop report and supply front-end and representative samples to the die corrector.
  • Report this job
    checkmark

    Thank you for reporting this job!

    Your feedback will help us improve the quality of our services.

    Apply
    My Email
    By clicking on "Continue", I give neuvoo consent to process my data and to send me email alerts, as detailed in neuvoo's Privacy Policy . I may withdraw my consent or unsubscribe at any time.
    Continue
    Application form